Nonbreakable stainless steel unit may be flame sterilized to sanitize the holder between samplings.
Can be sterilized by standard procedures including autoclaving. Luer fittings fit typical syringes. Can be tightened securely, wrench set included.
Female threaded locking ring enables filter changes without removing the holder from connecting gas lines. Dual support screens protect the membrane filter from reverse pressure surges and allow forward and reverse flow from either inlet or ...
Support screen is PTFE coated to prevent membrane sticking during autoclaving. Back pressure support screen prevents membrane rupture during reverse pressure surges. Vent valve in inlet body enables venting at any time during ...
Sanitary inlet and outlet connections are non-threaded and can be completely disassembled for thorough cleaning. 47 mm holder features vent to allow air venting on upstream side of the membrane at any time during filtration.
Operating at high pressure, up to 9.8MPa (1420 psi)
To prevent membrane rupture and deflet flow at very high pressure, Back Pressure Support Screen is available.
Seal membrane by hand tightening locking wing nuts. Optimal holder design minimizes resistance and maximizes flow rate. Available in either type 304 or type 316 stainless steel. Each unit labeled with identifying serial ...
Sanitary connections are threadless and can be completely disassembled for thorough cleaning. Designed for minimal resistance and maximal flow. Available in either type 304 or 316 stainless steel. Removable wing nuts tighten ...
Designed for filtering small batches of liquid without having to use a separate pressure vessel. Separate ports for pressurizing the reservoir and for adding additional sample. Membrane sealed internally by hand-tightening locking ...
Dual sealing system compresses the filter between the inside wall of the outlet plate and the O-ring on the outer edge. Broad range of media thickness, including pads, can be used without compromising sealing up to 3 mm. Multiple ...