Advantec > Parts and Accessories for Glass Vacuum Filter Holders

Membranes	Prefilters	Filter Papers & Thimbles	Microbiological Products
Filtration Accessories	Filter Holders	Cartridges and Capsules	Disposable Syringe Filter Units
Ultrafiltration	Food Analysis Products	Chromatography Products	Cartridge Housings
Environmental Monitoring Products

Glass Vacuum Filter Holders - Parts and Accessories (Filter Compatibility, Cleaning and Maintenance)

Funnels	filter holder size (mm)
size in ml	13	25	47	90
13/100*	311101	-	-	-
15 (25)	-	311201		-
100	311001	-	311408	-
150	-	311208	-	-
300	-	311209	311401	-
300 (Teflon seal)	-	-	351601	-
500	311005	-	311409	352108
1000	311010	-	311410	352101
*100 ml funnel mounts on 13 ml micro funnel by a ground glass joint


	13	25	47	90
Support System
Stainless steel support	-	311304	311504	352204	47 mm stainless steel and Teflon supports are interchangeable Teflon gasket is required with 25 and 47 mm stainless supports only Teflon flange is used with 311602 base and 351601 funnel for all-Teflon seal
Teflon gasket	-	311305	311505	-
Teflon support	-	-	311604	-
Teflon flange	-	-	351603	-
Clamp	311003	311003	311403	352103
Base
standard glass frit	311002	311202	311402	352102
for use with stainless steel or Teflon support	-	311302	311502	352202
for use with all-Teflon seal	-	-	311602	-
Silicone rubber stoppers
#5	311004	311004	-	-	fits 125 ml flask
#8B	311008	311008	-	-	fits 1000 ml flask or standard manifold
#8	-	-	311404	311404	fits 1000 ml flask or standard manifold
Extension	-	-	311450	-	A two-inch extension is available to set up two 47 mm filters in series. This extension will accept either the stainless or Teflon support screens. Note: Requires additional clamp.